E60
Insignia
Heating System General Error
Washer displays E60; heating function does not work or cycle times are extended.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed heater element, Faulty NTC temperature sensor, Loose heater wiring, Control board heater relay failure
How to Fix / Troubleshooting
Safety first: Unplug the washer before accessing heater components.
- Verify model capability: Confirm your Insignia washer model actually has an internal heater; some rely only on hot water supply.
- Inspect heater: Access the heater at the bottom of the tub from the rear. Check for burnt or damaged terminals.
- Test heater and sensor: Use a multimeter to check heater resistance and NTC sensor values. Replace any components that are open or out of spec.
- Check wiring: Ensure all connectors are tight and free of corrosion.
- Control board replacement: If heater and sensor are good, the main control board heater circuit may be faulty and require replacement.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Water Heater Element
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements