Washer will not start; F22 displayed; door may not lock or may click repeatedly.

Safety First: Unplug the washer before working around the door lock.

Steps:

• Inspect door strike: Check the plastic strike on the door for cracks or misalignment. Replace if damaged.
• Check door closure: Ensure the door closes firmly and is not obstructed by clothing or a twisted door boot.
• Access door lock: Remove the outer clamp from the door boot and peel the boot back near the lock. Remove the screws securing the door lock assembly and pull it out.
• Inspect and reseat wiring: Check the connector for loose or burnt pins. Reseat the harness.
• Test lock: With a meter, check continuity of the lock and switch circuits per the service manual. If readings are out of spec, replace the door lock assembly.
• Reassemble: Reinstall the lock, secure the boot and clamp, and test a cycle.

Note: Forcing the door open can damage the lock; always wait for the lock to release after power is removed.