Washer fills very slowly or not at all; may hum at the back where hoses connect.

Safety First: Unplug the washer and close both hot and cold water supply valves.

Steps:

• Check supply: Disconnect hoses from the back of the washer and run them into a bucket to verify strong water flow from the house valves.
• Clean inlet screens: Inspect the small screens inside the washer's inlet ports. Gently remove debris with a small brush; do not damage the screens.
• Inspect hoses: Ensure hoses are not kinked or crushed behind the washer.
• Replace inlet valve: If water supply is good and screens are clean but fill is still slow or absent, replace the Kenmore water inlet valve assembly.