Washer displays E10; no water enters or fill is extremely slow at the beginning of the cycle.

Safety first: Unplug the washer and close water taps before disconnecting hoses.

• Verify taps: Confirm that the water taps are fully open and that there is adequate water pressure.
• Clean filters: Remove hoses from the back of the washer and clean the mesh filters inside the valve inlets.
• Check valve coil: With power disconnected, remove the top or rear panel to access the inlet valve. Inspect wiring and test coil resistance with a multimeter. Replace the valve assembly if open or shorted.
• Inspect wiring: Trace the harness from the control board to the valve for damage or loose connectors. Repair or replace as needed.
• Test cycle: Reassemble, restore water and power, and run a quick wash to confirm proper filling.