Whirlpool Leaking Water Inlet Valve

Washer takes in water even when turned off, tub slowly fills over time.

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Stuck or worn inlet valve seat, debris in valve, excessive water pressure, incorrect hose installation with hot/cold reversed

How to Fix / Troubleshooting

Safety first: Turn off both hot and cold water supply valves immediately to stop the fill. Unplug the washer.

Step-by-step:

  • Confirm valve leak: With power off and water on, observe if water continues to enter. If so, the inlet valve is mechanically stuck open.
  • Inspect screens: Remove hoses and clean inlet screens. Debris can prevent proper sealing.
  • Replace valve: If water still leaks through with clean screens, replace the water inlet valve assembly with the correct Whirlpool part.

When to call a technician: If you are not comfortable replacing the valve or if plumbing modifications are needed, contact a professional.

Advertisements

Repair Difficulty

Medium 3/5

Required Part

Water Inlet Valve Assembly
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements