E9
Fisher & Paykel Refrigeration System Performance Fault

Wine cooler shows E9 and may run continuously or not reach set temperature; compressor may be very hot.

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Low refrigerant charge due to leak, restricted capillary tube, inefficient compressor, blocked condenser coil

How to Fix / Troubleshooting

Safety: Do not attempt to open or recharge the sealed refrigeration system unless you are a licensed refrigeration technician. Unplug the unit before cleaning or inspection.

Steps to address E9:

  • Clean condenser: Remove the rear lower panel and thoroughly clean the condenser coil to improve heat rejection.
  • Check condenser fan: Ensure the condenser fan runs whenever the compressor is on. Replace the fan motor if it does not operate.
  • Verify door seals: Inspect door gaskets for gaps or tears that could cause excessive run time. Replace damaged gaskets.
  • Monitor operation: After cleaning and basic checks, allow 24 hours for temperatures to stabilize. If E9 persists and the compressor runs nearly constantly with poor cooling, a sealed system issue (leak, restriction, or weak compressor) is likely.
  • Contact a professional: Sealed system repairs require specialized tools and refrigerant handling certification. Arrange service with an authorized Fisher & Paykel technician.
Advertisements

Repair Difficulty

Professional Required 5/5

Required Part

Compressor / Sealed Refrigeration System
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements