Hotpoint Wine Coolers Error Codes
Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.
Advertisements
E1
Wine cooler not cooling properly, temperature too warm, E1 displayed on control panel.
Cabinet Temperature Sensor (NTC) Failure
E10
E10 error, unit may not power up fully or may shut down unexpectedly.
Main Control Board Power Supply Fault
E11
E11 displayed, interior light may flicker or stay on, door alarm may sound incorrectly.
Interior Light Circuit Fault
E12
E12 error: Dual-zone wine cooler shows incorrect temperature in one zone.
Upper Zone Temperature Sensor Fault (Dual-Zone Models)
E13
E13 error: Lower zone temperature unstable or not responding to setpoint changes.
Lower Zone Temperature Sensor Fault (Dual-Zone Models)
E14
E14 displayed: Compressor runs continuously or not at all; temperature does not match setpoint.
Temperature Calibration / EEPROM Fault
E15
E15 error: Audible alarm, unit may shut down cooling as a safety precaution.
Sensor Short Circuit / Overrange Fault
E16
E16 displayed: Compressor and fan may not start; unit appears powered but does not cool.
Compressor Relay / Output Fault
E17
E17 error: Fan may run but compressor cycles abnormally; temperature is unstable.
Condenser Fan Feedback / Speed Fault
E18
E18 displayed: Unit may be noisy or shut down due to vibration protection.
Vibration / Tilt Sensor Fault
E2
Wine cooler shows E2 and may run continuously or shut off erratically.
Evaporator Temperature Sensor (NTC) Failure
E3
Display shows E3, temperature reading is erratic or dashes, unit may shut off prematurely.
Ambient / Room Temperature Sensor Failure
E4
E4 error on display, unit may not defrost properly, heavy ice buildup on evaporator.
Defrost Sensor or Defrost Circuit Failure
E5
E5 displayed, compressor does not start or cycles rapidly, interior warms up.
Compressor Start / Overload Protection Fault
E6
E6 error, fan noise stops or is intermittent, temperature uneven inside cabinet.
Evaporator Fan Motor Failure
E7
E7 displayed, interior light and controls may work but cooling is disabled.
Door Switch or Door Open Detection Fault
E8
E8 error, compressor and fan may stop, unit may beep continuously.
High Temperature Alarm / Overtemperature Fault
E9
E9 displayed, temperature setpoint cannot be adjusted correctly, display may flash.
Control Panel / Keypad Communication Fault
Symptom
Cabinet temperature fluctuates widely, overshooting the setpoint.
Poor Temperature Regulation
Symptom
Clicking sound every few minutes, compressor tries to start but shuts off, resulting in no cooling.
Compressor Hard Start / Overload Tripping
Symptom
Condensation or fogging on the glass door.
Door Seal or Ambient Humidity Issue
Symptom
Door does not close properly or pops open slightly after closing.
Door Alignment / Hinge or Gasket Issue
Symptom
Door gasket is torn, cracked, or hardened, causing air leaks.
Degraded Door Seal
Symptom
Dual-zone wine cooler: one zone cooling, the other warm.
Single-Zone Cooling Failure in Dual-Zone System
Symptom
Exterior side walls feel very hot to the touch.
High Cabinet Skin Temperature
Symptom
Frost or ice buildup on the back wall or around the evaporator area.
Defrost System Inefficiency or Air Infiltration
Symptom
Interior fan runs constantly, even when the set temperature is reached.
Fan Control or Sensor Feedback Issue
Symptom
Interior has a musty or moldy odor.
Microbial Growth Inside Cabinet
Symptom
Rattling or vibrating noise, especially when the compressor starts or stops.
Cabinet Vibration / Loose Components
Symptom
Temperature display flashing, but no specific error code; unit beeping periodically.
High Temperature or Door Ajar Alarm
Symptom
The display is on, but buttons do not respond or respond intermittently.
Unresponsive Touch Panel / Keypad
Symptom
Unit cycles on and off very frequently (short cycling).
Short Cycling of Compressor
Symptom
Unit emits a burning smell or visible smoke from the rear.
Electrical Overheating or Component Burnout
Symptom
Water pooling at the bottom of the wine cooler or on the floor in front of it.
Condensate Drain Blockage or Cabinet Condensation
Symptom
Wine cooler interior light is not working, but cooling is otherwise normal.
Interior LED Light Failure
Symptom
Wine cooler making a loud humming or buzzing noise from the rear.
Noisy Compressor or Condenser Fan
Symptom
Wine cooler not cooling at all: Interior at room temperature, display and lights work but no humming from the compressor.
Compressor Not Running
Symptom
Wine cooler runs but does not get cold enough; temperature is only slightly below room temperature.
Refrigerant Undercharge or Sealed System Inefficiency
Symptom
Wine cooler too cold: Bottles freezing or ice forming on the back wall.
Thermostat / Temperature Control Failure
Symptom
Wine cooler will not power on at all; the display is blank, and there are no lights.
No Power / Electrical Supply Failure
| Error Code | Symptom | Fault Type | Guide |
|---|---|---|---|
| E1 |
Wine cooler not cooling properly, temperature too warm, E1 displayed on control panel.
|
Cabinet Temperature Sensor (NTC) Failure | View Details |
| E10 |
E10 error, unit may not power up fully or may shut down unexpectedly.
|
Main Control Board Power Supply Fault | View Details |
| E11 |
E11 displayed, interior light may flicker or stay on, door alarm may sound incorrectly.
|
Interior Light Circuit Fault | View Details |
| E12 |
E12 error: Dual-zone wine cooler shows incorrect temperature in one zone.
|
Upper Zone Temperature Sensor Fault (Dual-Zone Models) | View Details |
| E13 |
E13 error: Lower zone temperature unstable or not responding to setpoint changes.
|
Lower Zone Temperature Sensor Fault (Dual-Zone Models) | View Details |
| E14 |
E14 displayed: Compressor runs continuously or not at all; temperature does not match setpoint.
|
Temperature Calibration / EEPROM Fault | View Details |
| E15 |
E15 error: Audible alarm, unit may shut down cooling as a safety precaution.
|
Sensor Short Circuit / Overrange Fault | View Details |
| E16 |
E16 displayed: Compressor and fan may not start; unit appears powered but does not cool.
|
Compressor Relay / Output Fault | View Details |
| E17 |
E17 error: Fan may run but compressor cycles abnormally; temperature is unstable.
|
Condenser Fan Feedback / Speed Fault | View Details |
| E18 |
E18 displayed: Unit may be noisy or shut down due to vibration protection.
|
Vibration / Tilt Sensor Fault | View Details |
| E2 |
Wine cooler shows E2 and may run continuously or shut off erratically.
|
Evaporator Temperature Sensor (NTC) Failure | View Details |
| E3 |
Display shows E3, temperature reading is erratic or dashes, unit may shut off prematurely.
|
Ambient / Room Temperature Sensor Failure | View Details |
| E4 |
E4 error on display, unit may not defrost properly, heavy ice buildup on evaporator.
|
Defrost Sensor or Defrost Circuit Failure | View Details |
| E5 |
E5 displayed, compressor does not start or cycles rapidly, interior warms up.
|
Compressor Start / Overload Protection Fault | View Details |
| E6 |
E6 error, fan noise stops or is intermittent, temperature uneven inside cabinet.
|
Evaporator Fan Motor Failure | View Details |
| E7 |
E7 displayed, interior light and controls may work but cooling is disabled.
|
Door Switch or Door Open Detection Fault | View Details |
| E8 |
E8 error, compressor and fan may stop, unit may beep continuously.
|
High Temperature Alarm / Overtemperature Fault | View Details |
| E9 |
E9 displayed, temperature setpoint cannot be adjusted correctly, display may flash.
|
Control Panel / Keypad Communication Fault | View Details |
| – |
Cabinet temperature fluctuates widely, overshooting the setpoint.
|
Poor Temperature Regulation | View Details |
| – |
Clicking sound every few minutes, compressor tries to start but shuts off, resulting in no cooling.
|
Compressor Hard Start / Overload Tripping | View Details |
| – |
Condensation or fogging on the glass door.
|
Door Seal or Ambient Humidity Issue | View Details |
| – |
Door does not close properly or pops open slightly after closing.
|
Door Alignment / Hinge or Gasket Issue | View Details |
| – |
Door gasket is torn, cracked, or hardened, causing air leaks.
|
Degraded Door Seal | View Details |
| – |
Dual-zone wine cooler: one zone cooling, the other warm.
|
Single-Zone Cooling Failure in Dual-Zone System | View Details |
| – |
Exterior side walls feel very hot to the touch.
|
High Cabinet Skin Temperature | View Details |
| – |
Frost or ice buildup on the back wall or around the evaporator area.
|
Defrost System Inefficiency or Air Infiltration | View Details |
| – |
Interior fan runs constantly, even when the set temperature is reached.
|
Fan Control or Sensor Feedback Issue | View Details |
| – |
Interior has a musty or moldy odor.
|
Microbial Growth Inside Cabinet | View Details |
| – |
Rattling or vibrating noise, especially when the compressor starts or stops.
|
Cabinet Vibration / Loose Components | View Details |
| – |
Temperature display flashing, but no specific error code; unit beeping periodically.
|
High Temperature or Door Ajar Alarm | View Details |
| – |
The display is on, but buttons do not respond or respond intermittently.
|
Unresponsive Touch Panel / Keypad | View Details |
| – |
Unit cycles on and off very frequently (short cycling).
|
Short Cycling of Compressor | View Details |
| – |
Unit emits a burning smell or visible smoke from the rear.
|
Electrical Overheating or Component Burnout | View Details |
| – |
Water pooling at the bottom of the wine cooler or on the floor in front of it.
|
Condensate Drain Blockage or Cabinet Condensation | View Details |
| – |
Wine cooler interior light is not working, but cooling is otherwise normal.
|
Interior LED Light Failure | View Details |
| – |
Wine cooler making a loud humming or buzzing noise from the rear.
|
Noisy Compressor or Condenser Fan | View Details |
| – |
Wine cooler not cooling at all: Interior at room temperature, display and lights work but no humming from the compressor.
|
Compressor Not Running | View Details |
| – |
Wine cooler runs but does not get cold enough; temperature is only slightly below room temperature.
|
Refrigerant Undercharge or Sealed System Inefficiency | View Details |
| – |
Wine cooler too cold: Bottles freezing or ice forming on the back wall.
|
Thermostat / Temperature Control Failure | View Details |
| – |
Wine cooler will not power on at all; the display is blank, and there are no lights.
|
No Power / Electrical Supply Failure | View Details |
No matching codes found
Advertisements