Washer-dryer displays a water leak or safety error; the machine may stop and attempt to drain continuously.

Safety first: Unplug the appliance and turn off the water supply immediately if a leak is suspected.

• Step 1 – Inspect for visible leaks: Look around and under the machine for water. Mop up any standing water.
• Step 2 – Access the base tray: Carefully tilt the machine slightly backward (with assistance) and check the base tray for water. If present, dry the tray completely with towels or a sponge.
• Step 3 – Locate the leak source: Remove the rear and/or side panels. Check the door seal, sump hose, tub-to-pump hose, inlet hoses, and detergent drawer hoses for splits, loose clamps, or drips. Run a short fill cycle while observing (with covers off only if you are competent and all live parts are shielded).
• Step 4 – Repair the leak: Tighten hose clamps, replace cracked hoses, or replace a damaged door seal as needed.
• Step 5 – Reset the leak sensor: Once the leak is fixed and the base is dry, restore power and test. If E30 persists with a dry base, the float switch or its wiring may be faulty and require replacement.