Essentials
Essentials Washer-Dryer Combos Error Codes
Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.
Advertisements
E01
Washer-dryer will not start; display shows E01 and door remains unlocked
Door Lock Circuit Fault
E02
Washer-dryer does not fill with water; E02 displayed shortly after cycle start
Water Inlet Timeout
E03
Washer-dryer fails to drain; water remains in drum and E03 is shown
Drain Pump Timeout
E04
Washer-dryer overfills or shows E04 with water visible in the door glass
Overfill / Water Level Sensor Error
E05
Washer-dryer does not heat water during wash; E05 displayed mid-cycle
Wash Heater Circuit Fault
E06
Drying cycle does not heat; clothes come out wet and cool; E06 is displayed.
Dryer Heater Circuit Fault
E07
Washer-dryer drum does not spin or tumble; E07 is displayed during wash or spin.
Motor Drive Fault
E08
Washer-dryer fails to reach full spin speed; E08 is displayed near the end of the cycle.
Unbalanced Load / Spin Protection Fault
E09
Washer-dryer stops mid-cycle and displays E09; the drum may be locked.
Motor Overcurrent / Short Circuit
E10
Washer-dryer door will not unlock at the end of the cycle; E10 is displayed.
Door Unlock Failure
E11
Washer-dryer stops with water in the drum and E11; the door remains locked.
Drain / Door Interlock Safety Fault
E12
Drying performance is poor; the cycle ends quickly with E12 displayed.
Dryer Airflow / Condenser Blockage
E13
Water leak detected; the washer-dryer stops and shows E13.
Leak / Anti-Flood System Activation
E14
Washer-dryer display shows E14, and controls are unresponsive or erratic.
Control Panel / User Interface Communication Error
E15
Washer-dryer shows E15 and will not start; often after a power surge.
Main Control PCB Fault / EEPROM Error
E16
Washer-dryer displays E16 and stops heating during drying; may restart after cooling.
Dryer Overheat Protection Activated
E17
Washer-dryer displays E17 and does not take in cold water.
Cold Water Inlet Valve Fault
E18
Washer-dryer displays E18 and does not take in hot water (on models with hot feed).
Hot Water Inlet Valve Fault
E19
Washer-dryer displays E19 and will not start drying; wash cycles may still work.
Dryer Circuit Communication / Relay Fault
E20
Washer-dryer displays E20 and stops during spin; drum may be full of suds.
Excessive Suds / Foam Detection
Symptom
Washer-dryer combo will not power on at all; no lights or display.
No Power / Dead Appliance
Symptom
Washer-dryer display and lights flicker or reset during spin.
Power Supply Instability / Vibration-Induced Interruption
Symptom
Washer-dryer door is difficult to open or close; the latch feels stiff.
Door Latch / Hinge Misalignment
Symptom
Washer-dryer drum does not tumble during drying but rotates during washing.
Dryer-Only Tumble Fault
Symptom
Washer-dryer emits a burning smell during wash or dry cycles.
Overheating / Electrical or Mechanical Friction
Symptom
Washer-dryer fills and drains, but the drum does not rotate during wash or spin (no error code).
Mechanical Drive Failure
Symptom
Washer-dryer has a persistent musty or moldy odor inside the drum.
Biofilm / Mold Build-Up
Symptom
Washer-dryer leaks water from the front door area during wash.
Door Seal / Gasket Leak
Symptom
Washer-dryer leaks water from the rear or underneath during drain or spin.
Internal Hose or Pump Leak
Symptom
Washer-dryer leaves clothes hot and damp after drying; the cycle seems to run but moisture remains.
Poor Drying / Condenser Inefficiency
Symptom
Washer-dryer leaves clothes very wet at the end of the cycle; spin seems weak or short.
Poor Spin Performance
Symptom
Washer-dryer leaves detergent residues or white streaks on clothes.
Poor Rinsing / Detergent Dispensing Issue
Symptom
Washer-dryer makes a scraping or grinding noise when the drum turns.
Foreign Object Between Drum and Tub
Symptom
Washer-dryer makes a very loud rumbling or roaring noise during spin.
Drum Bearing Failure
Symptom
Washer-dryer produces a loud banging or knocking noise during spin.
Excessive Vibration / Suspension Fault
Symptom
Washer-dryer takes much longer than expected to complete cycles.
Extended Cycle Time / Sensor Compensation
Symptom
Washer-dryer trips the household circuit breaker or RCD during operation.
Electrical Short or Earth Leakage
Symptom
Washer-dryer turns on but will not start any program; Start button unresponsive.
User Interface / Start Circuit Fault
| Error Code | Symptom | Fault Type | Guide |
|---|---|---|---|
| E01 |
Washer-dryer will not start; display shows E01 and door remains unlocked
|
Door Lock Circuit Fault | View Details |
| E02 |
Washer-dryer does not fill with water; E02 displayed shortly after cycle start
|
Water Inlet Timeout | View Details |
| E03 |
Washer-dryer fails to drain; water remains in drum and E03 is shown
|
Drain Pump Timeout | View Details |
| E04 |
Washer-dryer overfills or shows E04 with water visible in the door glass
|
Overfill / Water Level Sensor Error | View Details |
| E05 |
Washer-dryer does not heat water during wash; E05 displayed mid-cycle
|
Wash Heater Circuit Fault | View Details |
| E06 |
Drying cycle does not heat; clothes come out wet and cool; E06 is displayed.
|
Dryer Heater Circuit Fault | View Details |
| E07 |
Washer-dryer drum does not spin or tumble; E07 is displayed during wash or spin.
|
Motor Drive Fault | View Details |
| E08 |
Washer-dryer fails to reach full spin speed; E08 is displayed near the end of the cycle.
|
Unbalanced Load / Spin Protection Fault | View Details |
| E09 |
Washer-dryer stops mid-cycle and displays E09; the drum may be locked.
|
Motor Overcurrent / Short Circuit | View Details |
| E10 |
Washer-dryer door will not unlock at the end of the cycle; E10 is displayed.
|
Door Unlock Failure | View Details |
| E11 |
Washer-dryer stops with water in the drum and E11; the door remains locked.
|
Drain / Door Interlock Safety Fault | View Details |
| E12 |
Drying performance is poor; the cycle ends quickly with E12 displayed.
|
Dryer Airflow / Condenser Blockage | View Details |
| E13 |
Water leak detected; the washer-dryer stops and shows E13.
|
Leak / Anti-Flood System Activation | View Details |
| E14 |
Washer-dryer display shows E14, and controls are unresponsive or erratic.
|
Control Panel / User Interface Communication Error | View Details |
| E15 |
Washer-dryer shows E15 and will not start; often after a power surge.
|
Main Control PCB Fault / EEPROM Error | View Details |
| E16 |
Washer-dryer displays E16 and stops heating during drying; may restart after cooling.
|
Dryer Overheat Protection Activated | View Details |
| E17 |
Washer-dryer displays E17 and does not take in cold water.
|
Cold Water Inlet Valve Fault | View Details |
| E18 |
Washer-dryer displays E18 and does not take in hot water (on models with hot feed).
|
Hot Water Inlet Valve Fault | View Details |
| E19 |
Washer-dryer displays E19 and will not start drying; wash cycles may still work.
|
Dryer Circuit Communication / Relay Fault | View Details |
| E20 |
Washer-dryer displays E20 and stops during spin; drum may be full of suds.
|
Excessive Suds / Foam Detection | View Details |
| – |
Washer-dryer combo will not power on at all; no lights or display.
|
No Power / Dead Appliance | View Details |
| – |
Washer-dryer display and lights flicker or reset during spin.
|
Power Supply Instability / Vibration-Induced Interruption | View Details |
| – |
Washer-dryer door is difficult to open or close; the latch feels stiff.
|
Door Latch / Hinge Misalignment | View Details |
| – |
Washer-dryer drum does not tumble during drying but rotates during washing.
|
Dryer-Only Tumble Fault | View Details |
| – |
Washer-dryer emits a burning smell during wash or dry cycles.
|
Overheating / Electrical or Mechanical Friction | View Details |
| – |
Washer-dryer fills and drains, but the drum does not rotate during wash or spin (no error code).
|
Mechanical Drive Failure | View Details |
| – |
Washer-dryer has a persistent musty or moldy odor inside the drum.
|
Biofilm / Mold Build-Up | View Details |
| – |
Washer-dryer leaks water from the front door area during wash.
|
Door Seal / Gasket Leak | View Details |
| – |
Washer-dryer leaks water from the rear or underneath during drain or spin.
|
Internal Hose or Pump Leak | View Details |
| – |
Washer-dryer leaves clothes hot and damp after drying; the cycle seems to run but moisture remains.
|
Poor Drying / Condenser Inefficiency | View Details |
| – |
Washer-dryer leaves clothes very wet at the end of the cycle; spin seems weak or short.
|
Poor Spin Performance | View Details |
| – |
Washer-dryer leaves detergent residues or white streaks on clothes.
|
Poor Rinsing / Detergent Dispensing Issue | View Details |
| – |
Washer-dryer makes a scraping or grinding noise when the drum turns.
|
Foreign Object Between Drum and Tub | View Details |
| – |
Washer-dryer makes a very loud rumbling or roaring noise during spin.
|
Drum Bearing Failure | View Details |
| – |
Washer-dryer produces a loud banging or knocking noise during spin.
|
Excessive Vibration / Suspension Fault | View Details |
| – |
Washer-dryer takes much longer than expected to complete cycles.
|
Extended Cycle Time / Sensor Compensation | View Details |
| – |
Washer-dryer trips the household circuit breaker or RCD during operation.
|
Electrical Short or Earth Leakage | View Details |
| – |
Washer-dryer turns on but will not start any program; Start button unresponsive.
|
User Interface / Start Circuit Fault | View Details |
No matching codes found
Advertisements