Gram Washer-Dryer Combos Error Codes
Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.
Advertisements
E01
Washer-dryer will not start a cycle; the display shows E01, and the door symbol may flash.
Door Lock Failure
E02
Washer-dryer does not fill with water or fills very slowly; E02 is displayed after a few minutes.
Water Inlet Timeout
E03
Washer-dryer does not drain water; the cycle stops with water in the drum, and E03 is shown on the display.
Drain Pump Failure or Drainage Blockage
E04
Washer-dryer overfills or shows E04 shortly after starting; it may attempt to drain continuously.
Water Level Sensor / Overflow Fault
E05
Washer-dryer does not heat water during wash; clothes come out cold, and E05 appears.
Wash Heating Circuit Failure
E06
Drying function does not heat; laundry remains wet after the drying cycle, and E06 is displayed.
Dryer Heating Circuit Failure
E07
The drum does not rotate during wash or spin; a humming noise may be heard, and E07 is shown on the display.
Drive Motor or Motor Control Fault
E08
Washer-dryer fails to reach or maintain spin speed; E08 is displayed during the spin phase.
Unbalanced Load or Spin Control Fault
E09
Washer-dryer stops mid-cycle and displays E09; it may not respond to program changes.
Main Control PCB Communication or Power Fault
E10
Washer-dryer shows E10 and does not start drying; the wash cycle may complete normally.
Dryer Fan or Airflow Fault
E11
Washer-dryer door will not unlock at the end of the cycle; E11 is displayed.
Door Unlock Timeout
E12
The washer-dryer stops during drying with E12; the drum may rotate, but there is no effective drying.
Condenser or Moisture Sensor Fault
E13
Water is detected in the base tray; the washer-dryer stops and shows E13; the drain pump may run continuously.
Leak Detected / Anti-Flood Activation
E14
The washer-dryer shows E14 and does not respond correctly to button presses or knob rotation.
User Interface / Control Panel Fault
E15
The washer-dryer displays E15 and may trip the household breaker or RCD during operation.
Earth Leakage / Short Circuit in Heating or Motor Circuit
E16
The washer-dryer shows E16 and fails to detect the correct water level; it may stop early or not start spinning.
Pressure Sensor Signal Error
E17
The washer-dryer shows E17, and water does not enter despite open taps.
Inlet Valve Electrical Fault
E18
The washer-dryer shows E18 and stops with water remaining in the drum; the drain pump may run intermittently.
Drain Time Exceeded
E19
The washer-dryer shows E19 and may stop during heating phases of wash or dry.
NTC Temperature Sensor Fault
E20
The washer-dryer shows E20 and may not start or may stop unexpectedly; the display may flicker.
Power Supply / Voltage Error
Symptom
Burning smell or hot plastic odor during wash or dry cycles.
Overheating Component or Belt Slippage
Symptom
Clicking or scraping noise when drum turns, especially at low speed.
Foreign Object Between Drum and Tub
Symptom
Clothes come out very creased after wash-dry cycle.
Overdrying or Drum Speed Control Issue
Symptom
Detergent remains in drawer after wash; water overflows from dispenser.
Detergent Dispenser / Inlet Nozzle Blockage
Symptom
Display and lights flicker or reset when the washer-dryer starts spinning or heating.
Voltage Drop or Loose Connection
Symptom
Drying cycle runs but laundry remains damp or takes a very long time to dry.
Poor Drying Performance
Symptom
Unpleasant musty or moldy smell from drum and clothes.
Microbial Growth in Tub and Hoses
Symptom
Very loud rumbling or grinding noise during spinning; may worsen over time.
Drum Bearing Failure
Symptom
Washer-dryer combo leaks water from the front during wash cycles, especially at high water levels.
Door Gasket (Boot Seal) Leak
Symptom
Washer-dryer does not start; all lights are off even though it is plugged in.
No Power / Dead Appliance
Symptom
Washer-dryer door is difficult to open or does not latch smoothly.
Door Hinge or Latch Misalignment
Symptom
Washer-dryer leaves dark or greasy marks on clothes after washing.
Contamination in Drum or Bearing Seal Failure
Symptom
Washer-dryer makes a loud knocking or banging noise during spin.
Load Imbalance or Suspension Wear
Symptom
Washer-dryer stops mid-cycle with wet clothes; no error code is shown.
Intermittent Power or Control Fault
Symptom
Washer-dryer takes much longer than the displayed time to complete cycles.
Cycle Time Extension Due to Sensing
Symptom
Washer-dryer vibrates excessively or "walks" across the floor during spinning.
Excessive Vibration / Suspension Fault
Symptom
Washer-dryer will not start a cycle; the display works but the Start button does nothing.
Start Inhibit / Door or Control Logic Issue
Symptom
Water leaking from the rear or bottom of the washer-dryer during draining or spinning.
Drain System Leak
| Error Code | Symptom | Fault Type | Guide |
|---|---|---|---|
| E01 |
Washer-dryer will not start a cycle; the display shows E01, and the door symbol may flash.
|
Door Lock Failure | View Details |
| E02 |
Washer-dryer does not fill with water or fills very slowly; E02 is displayed after a few minutes.
|
Water Inlet Timeout | View Details |
| E03 |
Washer-dryer does not drain water; the cycle stops with water in the drum, and E03 is shown on the display.
|
Drain Pump Failure or Drainage Blockage | View Details |
| E04 |
Washer-dryer overfills or shows E04 shortly after starting; it may attempt to drain continuously.
|
Water Level Sensor / Overflow Fault | View Details |
| E05 |
Washer-dryer does not heat water during wash; clothes come out cold, and E05 appears.
|
Wash Heating Circuit Failure | View Details |
| E06 |
Drying function does not heat; laundry remains wet after the drying cycle, and E06 is displayed.
|
Dryer Heating Circuit Failure | View Details |
| E07 |
The drum does not rotate during wash or spin; a humming noise may be heard, and E07 is shown on the display.
|
Drive Motor or Motor Control Fault | View Details |
| E08 |
Washer-dryer fails to reach or maintain spin speed; E08 is displayed during the spin phase.
|
Unbalanced Load or Spin Control Fault | View Details |
| E09 |
Washer-dryer stops mid-cycle and displays E09; it may not respond to program changes.
|
Main Control PCB Communication or Power Fault | View Details |
| E10 |
Washer-dryer shows E10 and does not start drying; the wash cycle may complete normally.
|
Dryer Fan or Airflow Fault | View Details |
| E11 |
Washer-dryer door will not unlock at the end of the cycle; E11 is displayed.
|
Door Unlock Timeout | View Details |
| E12 |
The washer-dryer stops during drying with E12; the drum may rotate, but there is no effective drying.
|
Condenser or Moisture Sensor Fault | View Details |
| E13 |
Water is detected in the base tray; the washer-dryer stops and shows E13; the drain pump may run continuously.
|
Leak Detected / Anti-Flood Activation | View Details |
| E14 |
The washer-dryer shows E14 and does not respond correctly to button presses or knob rotation.
|
User Interface / Control Panel Fault | View Details |
| E15 |
The washer-dryer displays E15 and may trip the household breaker or RCD during operation.
|
Earth Leakage / Short Circuit in Heating or Motor Circuit | View Details |
| E16 |
The washer-dryer shows E16 and fails to detect the correct water level; it may stop early or not start spinning.
|
Pressure Sensor Signal Error | View Details |
| E17 |
The washer-dryer shows E17, and water does not enter despite open taps.
|
Inlet Valve Electrical Fault | View Details |
| E18 |
The washer-dryer shows E18 and stops with water remaining in the drum; the drain pump may run intermittently.
|
Drain Time Exceeded | View Details |
| E19 |
The washer-dryer shows E19 and may stop during heating phases of wash or dry.
|
NTC Temperature Sensor Fault | View Details |
| E20 |
The washer-dryer shows E20 and may not start or may stop unexpectedly; the display may flicker.
|
Power Supply / Voltage Error | View Details |
| – |
Burning smell or hot plastic odor during wash or dry cycles.
|
Overheating Component or Belt Slippage | View Details |
| – |
Clicking or scraping noise when drum turns, especially at low speed.
|
Foreign Object Between Drum and Tub | View Details |
| – |
Clothes come out very creased after wash-dry cycle.
|
Overdrying or Drum Speed Control Issue | View Details |
| – |
Detergent remains in drawer after wash; water overflows from dispenser.
|
Detergent Dispenser / Inlet Nozzle Blockage | View Details |
| – |
Display and lights flicker or reset when the washer-dryer starts spinning or heating.
|
Voltage Drop or Loose Connection | View Details |
| – |
Drying cycle runs but laundry remains damp or takes a very long time to dry.
|
Poor Drying Performance | View Details |
| – |
Unpleasant musty or moldy smell from drum and clothes.
|
Microbial Growth in Tub and Hoses | View Details |
| – |
Very loud rumbling or grinding noise during spinning; may worsen over time.
|
Drum Bearing Failure | View Details |
| – |
Washer-dryer combo leaks water from the front during wash cycles, especially at high water levels.
|
Door Gasket (Boot Seal) Leak | View Details |
| – |
Washer-dryer does not start; all lights are off even though it is plugged in.
|
No Power / Dead Appliance | View Details |
| – |
Washer-dryer door is difficult to open or does not latch smoothly.
|
Door Hinge or Latch Misalignment | View Details |
| – |
Washer-dryer leaves dark or greasy marks on clothes after washing.
|
Contamination in Drum or Bearing Seal Failure | View Details |
| – |
Washer-dryer makes a loud knocking or banging noise during spin.
|
Load Imbalance or Suspension Wear | View Details |
| – |
Washer-dryer stops mid-cycle with wet clothes; no error code is shown.
|
Intermittent Power or Control Fault | View Details |
| – |
Washer-dryer takes much longer than the displayed time to complete cycles.
|
Cycle Time Extension Due to Sensing | View Details |
| – |
Washer-dryer vibrates excessively or "walks" across the floor during spinning.
|
Excessive Vibration / Suspension Fault | View Details |
| – |
Washer-dryer will not start a cycle; the display works but the Start button does nothing.
|
Start Inhibit / Door or Control Logic Issue | View Details |
| – |
Water leaking from the rear or bottom of the washer-dryer during draining or spinning.
|
Drain System Leak | View Details |
No matching codes found
Advertisements