Miele Washer-Dryer Combos Error Codes
Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.
Advertisements
F10
Washer-dryer does not fill with water, cycle will not start, or stops shortly after starting.
Water Inlet Fault
F11
Washer-dryer will not drain, water remains in the drum, program stops with a drain error.
Drainage Fault
F12
Washer-dryer does not take in water, has intermittent filling, or long fill times.
Cold Water Inlet Communication Fault
F13
Washer-dryer does not take in hot water or fails on programs requiring a hot fill.
Hot Water Inlet Fault
F20
Washer-dryer stops heating, clothes come out cold, or the drying function is weak or not working.
Heating Fault (Wash or Dry Circuit)
F24
Washer-dryer displays a heating-related error, water overheats, or does not reach the correct temperature.
Temperature Sensor (NTC) Fault
F32
Door will not lock, the program will not start, or a door lock error is displayed.
Door Locking System Fault
F34
The door cannot be opened at the end of a cycle, or a door lock error appears mid-cycle.
Door Lock Position Fault
F35
Washer-dryer reports the door open even when closed; the cycle will not start.
Door Status Detection Fault
F39
Washer-dryer shows a general control fault; it may not start or may stop mid-cycle.
Control Electronics Fault
F50
Drum does not turn, or turns briefly then stops with a motor error.
Drive Motor Fault
F51
Unbalanced load error, drum attempts to spin but stops, spin speed not reached.
Unbalance Detection Fault
F53
Washer-dryer will not spin or wash, motor error displayed.
Motor Tachometer Signal Fault
F55
Washer-dryer stops with a water level error, may overfill or underfill.
Water Level Pressure Sensor Fault
F63
Washer-dryer displays a safety or waterproof system error, may not operate.
Waterproof System / Safety Fault
F66
Drying function fails, dryer fan or heater error displayed.
Dryer Heater / Fan Fault
F70
Washer-dryer shows waterproof system activated, machine may run drain pump continuously.
Waterproof System Activation
F78
Circulation or drain pump error, machine may not wash or rinse correctly.
Pump Communication / Performance Fault
F92
Washer-dryer reports detergent dispensing or TwinDos system error (if equipped).
Detergent Dispensing System Fault
F93
Washer-dryer indicates drying system fault, poor or no drying performance.
Drying System Control Fault
F95
Washer-dryer shows a communication error between the main control and user interface.
Communication Bus Fault
Symptom
Detergent remains in drawer compartments after wash, or water overflows from drawer
Detergent Drawer / Inlet Nozzle Blockage
Symptom
High-pitched squealing or scraping noise when drum turns.
Drum Support or Foreign Object Noise
Symptom
Loud rumbling or grinding noise during spin, even with balanced loads.
Drum Bearing Failure
Symptom
Washer-dryer does not start at all; no lights or display.
No Power / Supply Fault
Symptom
Washer-dryer door glass becomes extremely hot during drying
Overheating in Drying Circuit
Symptom
Washer-dryer drum does not turn during drying, but heats up
Drive Failure in Drying Mode
Symptom
Washer-dryer emits a burning smell during wash or dry cycles
Overheating or Electrical Burning
Symptom
Washer-dryer has a persistent musty or moldy odor inside the drum
Biofilm and Mold Buildup
Symptom
Washer-dryer leaks water from the front during wash or dry cycles.
Door Seal (Gasket) Leak
Symptom
Washer-dryer leaves clothes very wet after the spin cycle, even though the cycle completes.
Poor Spin Extraction
Symptom
Washer-dryer leaves visible detergent or white streaks on clothes
Detergent Dispensing / Rinsing Issue
Symptom
Washer-dryer makes clicking or rattling noises during wash or spin
Foreign Objects in Drum or Pump
Symptom
Washer-dryer powers on but will not start any program; the start button is unresponsive.
User Interface / Control Lock Issue
Symptom
Washer-dryer stops mid-cycle and does not progress, but no error code is shown
Program Stalling / Sensor Feedback Issue
Symptom
Washer-dryer takes a very long time to dry, or clothes remain damp at the end of the drying cycle.
Poor Drying Performance
Symptom
Washer-dryer trips the household circuit breaker or RCD during operation
Electrical Short or Earth Leakage
Symptom
Washer-dryer vibrates excessively or "walks" across the floor during spin.
Excessive Vibration / Suspension Fault
Symptom
Water leaking from underneath the washer-dryer, especially during fill or drain.
Internal Hose or Pump Leak
| Error Code | Symptom | Fault Type | Guide |
|---|---|---|---|
| F10 |
Washer-dryer does not fill with water, cycle will not start, or stops shortly after starting.
|
Water Inlet Fault | View Details |
| F11 |
Washer-dryer will not drain, water remains in the drum, program stops with a drain error.
|
Drainage Fault | View Details |
| F12 |
Washer-dryer does not take in water, has intermittent filling, or long fill times.
|
Cold Water Inlet Communication Fault | View Details |
| F13 |
Washer-dryer does not take in hot water or fails on programs requiring a hot fill.
|
Hot Water Inlet Fault | View Details |
| F20 |
Washer-dryer stops heating, clothes come out cold, or the drying function is weak or not working.
|
Heating Fault (Wash or Dry Circuit) | View Details |
| F24 |
Washer-dryer displays a heating-related error, water overheats, or does not reach the correct temperature.
|
Temperature Sensor (NTC) Fault | View Details |
| F32 |
Door will not lock, the program will not start, or a door lock error is displayed.
|
Door Locking System Fault | View Details |
| F34 |
The door cannot be opened at the end of a cycle, or a door lock error appears mid-cycle.
|
Door Lock Position Fault | View Details |
| F35 |
Washer-dryer reports the door open even when closed; the cycle will not start.
|
Door Status Detection Fault | View Details |
| F39 |
Washer-dryer shows a general control fault; it may not start or may stop mid-cycle.
|
Control Electronics Fault | View Details |
| F50 |
Drum does not turn, or turns briefly then stops with a motor error.
|
Drive Motor Fault | View Details |
| F51 |
Unbalanced load error, drum attempts to spin but stops, spin speed not reached.
|
Unbalance Detection Fault | View Details |
| F53 |
Washer-dryer will not spin or wash, motor error displayed.
|
Motor Tachometer Signal Fault | View Details |
| F55 |
Washer-dryer stops with a water level error, may overfill or underfill.
|
Water Level Pressure Sensor Fault | View Details |
| F63 |
Washer-dryer displays a safety or waterproof system error, may not operate.
|
Waterproof System / Safety Fault | View Details |
| F66 |
Drying function fails, dryer fan or heater error displayed.
|
Dryer Heater / Fan Fault | View Details |
| F70 |
Washer-dryer shows waterproof system activated, machine may run drain pump continuously.
|
Waterproof System Activation | View Details |
| F78 |
Circulation or drain pump error, machine may not wash or rinse correctly.
|
Pump Communication / Performance Fault | View Details |
| F92 |
Washer-dryer reports detergent dispensing or TwinDos system error (if equipped).
|
Detergent Dispensing System Fault | View Details |
| F93 |
Washer-dryer indicates drying system fault, poor or no drying performance.
|
Drying System Control Fault | View Details |
| F95 |
Washer-dryer shows a communication error between the main control and user interface.
|
Communication Bus Fault | View Details |
| – |
Detergent remains in drawer compartments after wash, or water overflows from drawer
|
Detergent Drawer / Inlet Nozzle Blockage | View Details |
| – |
High-pitched squealing or scraping noise when drum turns.
|
Drum Support or Foreign Object Noise | View Details |
| – |
Loud rumbling or grinding noise during spin, even with balanced loads.
|
Drum Bearing Failure | View Details |
| – |
Washer-dryer does not start at all; no lights or display.
|
No Power / Supply Fault | View Details |
| – |
Washer-dryer door glass becomes extremely hot during drying
|
Overheating in Drying Circuit | View Details |
| – |
Washer-dryer drum does not turn during drying, but heats up
|
Drive Failure in Drying Mode | View Details |
| – |
Washer-dryer emits a burning smell during wash or dry cycles
|
Overheating or Electrical Burning | View Details |
| – |
Washer-dryer has a persistent musty or moldy odor inside the drum
|
Biofilm and Mold Buildup | View Details |
| – |
Washer-dryer leaks water from the front during wash or dry cycles.
|
Door Seal (Gasket) Leak | View Details |
| – |
Washer-dryer leaves clothes very wet after the spin cycle, even though the cycle completes.
|
Poor Spin Extraction | View Details |
| – |
Washer-dryer leaves visible detergent or white streaks on clothes
|
Detergent Dispensing / Rinsing Issue | View Details |
| – |
Washer-dryer makes clicking or rattling noises during wash or spin
|
Foreign Objects in Drum or Pump | View Details |
| – |
Washer-dryer powers on but will not start any program; the start button is unresponsive.
|
User Interface / Control Lock Issue | View Details |
| – |
Washer-dryer stops mid-cycle and does not progress, but no error code is shown
|
Program Stalling / Sensor Feedback Issue | View Details |
| – |
Washer-dryer takes a very long time to dry, or clothes remain damp at the end of the drying cycle.
|
Poor Drying Performance | View Details |
| – |
Washer-dryer trips the household circuit breaker or RCD during operation
|
Electrical Short or Earth Leakage | View Details |
| – |
Washer-dryer vibrates excessively or "walks" across the floor during spin.
|
Excessive Vibration / Suspension Fault | View Details |
| – |
Water leaking from underneath the washer-dryer, especially during fill or drain.
|
Internal Hose or Pump Leak | View Details |
No matching codes found
Advertisements