E24
AEG
Drain Pump Feedback / Wiring Error
AEG washer shows E24, often related to drain pump control or wiring issues
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Loose connector at drain pump, Broken wiring between pump and control board, Faulty main control board output, Water ingress into wiring connectors
How to Fix / Troubleshooting
Safety first: Disconnect the washer from mains power.
- Check connectors: Access the drain pump and main control board. Unplug and re-seat the connectors to the pump and board, ensuring they click firmly into place.
- Inspect wiring harness: Follow the cable from the pump to the board. Look for crushed, cut, or burnt sections, especially where the harness passes over metal edges.
- Dry any moisture: If connectors are damp, dry them thoroughly and investigate for leaks that may be dripping onto the wiring.
If wiring and connectors are intact and E24 persists, the control board may be defective and should be checked by an AEG service technician.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
AEG Wiring Harness to Drain Pump
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements