AEG washing machine shows E62, water overheats, possible steam from door

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Shorted heater relay on control board, Faulty NTC sensor reading too low, Heater stuck on

Safety first: Unplug the washer immediately and allow it to cool. Overheating is a fire risk.

Test NTC sensor: Measure resistance at room temperature and compare to AEG specifications. Replace if out of range.
Inspect control board: Look for a stuck heater relay or burnt area near heater control.

Because of the safety implications, E62 should be handled by a qualified technician. Do not use the machine until repaired.

Professional Required 5/5

AEG NTC Temperature Sensor

Check Price on Amazon

We may earn a commission from links on this page.