Washer does not fill within the expected time; E10 is displayed early in the cycle.

Safety first: Unplug the washer and close water taps before disconnecting hoses.

Step-by-step checks:

• Confirm water pressure: Open nearby faucets to verify strong water flow. If household pressure is low, consult a plumber.
• Check taps and hoses: Ensure both hot and cold taps are fully open. Inspect hoses for kinks or crushing. Straighten or replace as needed.
• Clean inlet filters: Remove hoses from the washer and pull out the mesh filters. Clean thoroughly and reinstall.
• Test fill performance: Reconnect hoses, restore power, and start a quick wash. Observe fill speed. If still slow, the inlet valve may be weak or partially blocked internally and should be replaced.