Amana Wine Coolers Error Codes
Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.
Advertisements
dO
Wine cooler displays dO or DO and beeps; the interior light may stay on.
Door open or door switch error.
E1
Wine cooler displays E1, and the interior temperature is much warmer than the set temperature.
Cabinet (compartment) temperature sensor failure
E2
Wine cooler displays E2 and runs continuously or not at all; temperature is unstable.
Evaporator temperature sensor failure
E3
Wine cooler displays E3, and the interior temperature reading is obviously incorrect (e.g., shows 10°F when the room is 70°F).
Ambient (room) temperature sensor failure
E4
Wine cooler displays E4, and the compressor does not start or cycles rapidly.
Defrost sensor or defrost circuit fault
E5
Wine cooler displays E5, and interior temperature drifts; the unit may short-cycle.
Compressor discharge or condenser temperature sensor fault.
E6
Wine cooler displays E6, and the display or buttons behave erratically.
User interface (UI) communication error.
E7
Wine cooler displays E7, and the interior fan does not run or runs intermittently.
Evaporator fan feedback or fan circuit error.
E8
Wine cooler displays E8, and the unit will not cool; the compressor does not start.
Compressor start or overload protection fault.
E9
Wine cooler displays E9, and the interior temperature is too cold or too warm despite the setpoint.
Temperature calibration or EEPROM error.
Er
Wine cooler intermittently displays 'Er' or 'ERR' and beeps, but continues to run.
General sensor or control error
F1
Wine cooler displays F1 and will not accept temperature changes.
Keypad or touch control failure.
F2
Wine cooler displays F2, and the interior light does not operate correctly.
Lighting circuit or LED driver fault.
F3
Wine cooler displays F3, and the unit may shut down unexpectedly.
Over-temperature protection or high-current fault
F4
Wine cooler displays F4, and the unit will not power on or shuts off immediately.
Power supply or low-voltage DC fault
H1
Wine cooler displays H1 or HI, and the interior temperature is very warm.
High temperature alarm condition.
L1
Wine cooler displays L1 or LO, and the interior temperature is much colder than the setpoint; bottles may be freezing.
Low temperature alarm or runaway cooling.
Symptom
Dual-zone Amana wine cooler: one zone cools properly while the other is too warm.
Single-Zone Cooling Failure in Dual-Zone System
Symptom
Dual-zone Amana wine cooler: temperatures of both zones are the same despite different setpoints.
Loss of Independent Zone Control
Symptom
Excessive condensation or fogging on the glass door.
Door Condensation
Symptom
Excessive frost buildup on bottles and interior walls
Frost accumulation
Symptom
Interior light does not turn on when the door is opened
Interior lighting failure
Symptom
Interior light stays on even when the door is closed, causing warming inside
Light stuck on
Symptom
The display shows the temperature, but the buttons do not respond to touch or presses.
Unresponsive Control Panel
Symptom
The displayed temperature does not match the actual temperature inside the wine cooler.
Temperature Display Calibration Error
Symptom
The wine cooler door does not close properly or pops open.
Door Alignment or Gasket Issue
Symptom
The wine cooler emits a burning or electrical smell.
Overheating Electrical Component
Symptom
The wine cooler emits a chemical or refrigerant-like odor.
Possible Refrigerant Leak
Symptom
The wine cooler emits a musty or moldy odor inside.
Interior Odor Contamination
Symptom
The wine cooler trips the household circuit breaker or GFCI outlet.
Electrical Short or Ground Fault
Symptom
Water or frost is accumulating on the interior back wall or floor of the wine cooler
Interior condensation or defrost drainage issue
Symptom
Wine cooler cycles on and off rapidly (short cycling).
Short cycling of the compressor
Symptom
Wine cooler emits a high-pitched squealing or chirping noise
Fan bearing wear or motor failure
Symptom
Wine cooler is cooling, but the temperature is too warm and never reaches the setpoint.
Insufficient cooling capacity or airflow restriction
Symptom
Wine cooler is leaking water onto the floor from the front or rear
Drainage or condensation leak
Symptom
Wine cooler is too cold; wine or beverages are freezing.
Thermostat or temperature control failure
Symptom
Wine cooler is vibrating excessively and may move or rattle against cabinets
Excessive vibration
Symptom
Wine cooler lights and display work, but the compressor and fans never start.
Compressor control or start circuit failure
Symptom
Wine cooler makes a gurgling or hissing sound periodically
Normal refrigerant flow noise
Symptom
Wine cooler makes loud humming or buzzing noise from the rear
Compressor or condenser fan noise
Symptom
Wine cooler makes loud rattling or banging noise inside the cabinet during operation
Internal vibration or loose components
Symptom
Wine cooler runs but does not cool; the interior stays near room temperature.
Sealed system failure or loss of refrigerant
Symptom
Wine cooler runs continuously and never shuts off.
Continuous run condition
Symptom
Wine cooler will not turn on at all; no lights, no display, no sound.
No power condition
| Error Code | Symptom | Fault Type | Guide |
|---|---|---|---|
| dO |
Wine cooler displays dO or DO and beeps; the interior light may stay on.
|
Door open or door switch error. | View Details |
| E1 |
Wine cooler displays E1, and the interior temperature is much warmer than the set temperature.
|
Cabinet (compartment) temperature sensor failure | View Details |
| E2 |
Wine cooler displays E2 and runs continuously or not at all; temperature is unstable.
|
Evaporator temperature sensor failure | View Details |
| E3 |
Wine cooler displays E3, and the interior temperature reading is obviously incorrect (e.g., shows 10°F when the room is 70°F).
|
Ambient (room) temperature sensor failure | View Details |
| E4 |
Wine cooler displays E4, and the compressor does not start or cycles rapidly.
|
Defrost sensor or defrost circuit fault | View Details |
| E5 |
Wine cooler displays E5, and interior temperature drifts; the unit may short-cycle.
|
Compressor discharge or condenser temperature sensor fault. | View Details |
| E6 |
Wine cooler displays E6, and the display or buttons behave erratically.
|
User interface (UI) communication error. | View Details |
| E7 |
Wine cooler displays E7, and the interior fan does not run or runs intermittently.
|
Evaporator fan feedback or fan circuit error. | View Details |
| E8 |
Wine cooler displays E8, and the unit will not cool; the compressor does not start.
|
Compressor start or overload protection fault. | View Details |
| E9 |
Wine cooler displays E9, and the interior temperature is too cold or too warm despite the setpoint.
|
Temperature calibration or EEPROM error. | View Details |
| Er |
Wine cooler intermittently displays 'Er' or 'ERR' and beeps, but continues to run.
|
General sensor or control error | View Details |
| F1 |
Wine cooler displays F1 and will not accept temperature changes.
|
Keypad or touch control failure. | View Details |
| F2 |
Wine cooler displays F2, and the interior light does not operate correctly.
|
Lighting circuit or LED driver fault. | View Details |
| F3 |
Wine cooler displays F3, and the unit may shut down unexpectedly.
|
Over-temperature protection or high-current fault | View Details |
| F4 |
Wine cooler displays F4, and the unit will not power on or shuts off immediately.
|
Power supply or low-voltage DC fault | View Details |
| H1 |
Wine cooler displays H1 or HI, and the interior temperature is very warm.
|
High temperature alarm condition. | View Details |
| L1 |
Wine cooler displays L1 or LO, and the interior temperature is much colder than the setpoint; bottles may be freezing.
|
Low temperature alarm or runaway cooling. | View Details |
| – |
Dual-zone Amana wine cooler: one zone cools properly while the other is too warm.
|
Single-Zone Cooling Failure in Dual-Zone System | View Details |
| – |
Dual-zone Amana wine cooler: temperatures of both zones are the same despite different setpoints.
|
Loss of Independent Zone Control | View Details |
| – |
Excessive condensation or fogging on the glass door.
|
Door Condensation | View Details |
| – |
Excessive frost buildup on bottles and interior walls
|
Frost accumulation | View Details |
| – |
Interior light does not turn on when the door is opened
|
Interior lighting failure | View Details |
| – |
Interior light stays on even when the door is closed, causing warming inside
|
Light stuck on | View Details |
| – |
The display shows the temperature, but the buttons do not respond to touch or presses.
|
Unresponsive Control Panel | View Details |
| – |
The displayed temperature does not match the actual temperature inside the wine cooler.
|
Temperature Display Calibration Error | View Details |
| – |
The wine cooler door does not close properly or pops open.
|
Door Alignment or Gasket Issue | View Details |
| – |
The wine cooler emits a burning or electrical smell.
|
Overheating Electrical Component | View Details |
| – |
The wine cooler emits a chemical or refrigerant-like odor.
|
Possible Refrigerant Leak | View Details |
| – |
The wine cooler emits a musty or moldy odor inside.
|
Interior Odor Contamination | View Details |
| – |
The wine cooler trips the household circuit breaker or GFCI outlet.
|
Electrical Short or Ground Fault | View Details |
| – |
Water or frost is accumulating on the interior back wall or floor of the wine cooler
|
Interior condensation or defrost drainage issue | View Details |
| – |
Wine cooler cycles on and off rapidly (short cycling).
|
Short cycling of the compressor | View Details |
| – |
Wine cooler emits a high-pitched squealing or chirping noise
|
Fan bearing wear or motor failure | View Details |
| – |
Wine cooler is cooling, but the temperature is too warm and never reaches the setpoint.
|
Insufficient cooling capacity or airflow restriction | View Details |
| – |
Wine cooler is leaking water onto the floor from the front or rear
|
Drainage or condensation leak | View Details |
| – |
Wine cooler is too cold; wine or beverages are freezing.
|
Thermostat or temperature control failure | View Details |
| – |
Wine cooler is vibrating excessively and may move or rattle against cabinets
|
Excessive vibration | View Details |
| – |
Wine cooler lights and display work, but the compressor and fans never start.
|
Compressor control or start circuit failure | View Details |
| – |
Wine cooler makes a gurgling or hissing sound periodically
|
Normal refrigerant flow noise | View Details |
| – |
Wine cooler makes loud humming or buzzing noise from the rear
|
Compressor or condenser fan noise | View Details |
| – |
Wine cooler makes loud rattling or banging noise inside the cabinet during operation
|
Internal vibration or loose components | View Details |
| – |
Wine cooler runs but does not cool; the interior stays near room temperature.
|
Sealed system failure or loss of refrigerant | View Details |
| – |
Wine cooler runs continuously and never shuts off.
|
Continuous run condition | View Details |
| – |
Wine cooler will not turn on at all; no lights, no display, no sound.
|
No power condition | View Details |
No matching codes found
Advertisements