Monogram Dryers Error Codes
Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.
Advertisements
E01
Dryer will not start, display shows E01 shortly after pressing Start
Door Switch or Door Latch Fault
E02
Dryer stops shortly after starting, display shows E02, clothes remain wet
Exhaust Airflow Restriction
E03
Dryer will not start, E03 appears on display, control beeps
Control Panel or User Interface Communication Error
E04
Dryer runs briefly then shuts off with E04, drum may be hot
Exhaust Thermistor or Temperature Sensor Fault
E05
Dryer will not heat, E05 displayed, cycle may continue with cool air only
Inlet Thermistor or Temperature Sensor Fault
E06
Dryer does not heat properly, E06 appears intermittently during cycle
Moisture Sensor Circuit Fault
E07
Dryer drum does not turn, motor hums or stops, E07 displayed
Drive Motor or Motor Circuit Fault
E08
Dryer overheats or shuts down with E08, exterior of cabinet feels very hot
Overtemperature / High Limit Thermostat Trip
E09
Dryer will not heat, E09 displayed on gas models
Gas Ignition or Gas Valve Fault
E10
Dryer will not heat, E10 displayed on electric models.
Electric Heater Circuit Fault
E11
Dryer stops mid-cycle and displays E11; it will restart but stops again.
Motor Overload or Overcurrent Fault
E12
Dryer display shows E12; controls are unresponsive or erratic.
Main Control Board Failure
E13
Dryer beeps and shows E13; the drum light may stay on, and the unit will not start.
Door Lock / Door Sensing Error
E14
Dryer displays E14 and will not start or stops quickly, often after a power outage.
Line Voltage or Power Supply Error
E15
Dryer shows E15; drum light and display may flicker, and the unit may shut off unexpectedly.
Internal Low Voltage / Control Power Supply Error
E16
Dryer displays E16; sensor dry cycles end too quickly or run too long.
Humidity / Sensor Dry Calibration Error
E17
Dryer displays E17; the drum light works, but the Start button does nothing.
Start Button / User Interface Key Failure
E18
Dryer displays E18; the drum turns but there is no heat, often after long vent runs.
Exhaust Temperature Too Low / Vent Sensor Error
E19
Dryer displays E19; the cycle will not start or stops immediately after starting.
Drum Motor Tachometer / Speed Sensor Error
E20
Dryer displays E20, interior light may stay on, door status is incorrect.
Door Open Detection Error
Symptom
Dryer control panel buttons are unresponsive or respond intermittently.
User Interface or Touchpad Failure
Symptom
Dryer door is hard to open or close, with a scraping noise at the front.
Misaligned Door or Worn Front Drum Glide
Symptom
Dryer door pops open during the cycle, stopping the dryer.
Door Latch or Hinge Misalignment
Symptom
Dryer drum does not turn but motor can be heard running; a burning smell may be present.
Broken or Slipped Drive Belt
Symptom
Dryer drum light does not work, but the dryer otherwise operates normally.
Drum Light Circuit Failure
Symptom
Dryer interior light stays on even when the door is closed.
Door Switch Stuck or Misadjusted
Symptom
Dryer leaves black or brown marks on clothing.
Drum Seal or Felt Wear Causing Fabric Pinching
Symptom
Dryer makes loud rumbling or thumping noises during operation.
Worn Drum Support Rollers or Drum Glides
Symptom
Dryer powers on but will not start when Start is pressed; a click may be heard.
Start Circuit or Door Interlock Issue
Symptom
Dryer produces a burning smell during operation, but clothes are not scorched.
Lint or Debris Contacting Heater or Exhaust
Symptom
Dryer runs but clothes remain damp at the end of an automatic (sensor) cycle; timed dry works normally.
Moisture Sensor Not Detecting Properly
Symptom
Dryer runs but does not heat (electric Monogram dryer, no error code displayed).
Heating Element or Thermal Cutoff Failure
Symptom
Dryer runs continuously and does not shut off at the end of the cycle unless manually stopped.
Timer or Control Board Stuck On
Symptom
Dryer shuts off after a few minutes and will restart after cooling down.
Overheating Motor or Thermal Protection Trip
Symptom
Dryer squeals or squeaks loudly, especially at start-up.
Worn Idler Pulley or Drum Bearings
Symptom
Dryer stops with clothes very hot and wrinkled; the cycle seems too hot.
Temperature Regulation Problem
Symptom
Dryer takes too long to dry clothes, multiple cycles needed, drum feels warm but exhaust airflow is weak.
Restricted Exhaust Venting
Symptom
Dryer vibrates excessively or moves across the floor during operation.
Cabinet Vibration / Leveling Issue
Symptom
Dryer will not start at all; no lights or display, outlet has power.
No Power to Control / Blown Thermal Fuse
Symptom
Gas Monogram dryer runs but does not heat, no error code, igniter may glow briefly or not at all.
Gas Burner Ignition Failure
Symptom
The dryer emits a musty or moldy odor on startup or during drying.
Odor from Lint, Residue, or Environmental Contaminants
| Error Code | Symptom | Fault Type | Guide |
|---|---|---|---|
| E01 |
Dryer will not start, display shows E01 shortly after pressing Start
|
Door Switch or Door Latch Fault | View Details |
| E02 |
Dryer stops shortly after starting, display shows E02, clothes remain wet
|
Exhaust Airflow Restriction | View Details |
| E03 |
Dryer will not start, E03 appears on display, control beeps
|
Control Panel or User Interface Communication Error | View Details |
| E04 |
Dryer runs briefly then shuts off with E04, drum may be hot
|
Exhaust Thermistor or Temperature Sensor Fault | View Details |
| E05 |
Dryer will not heat, E05 displayed, cycle may continue with cool air only
|
Inlet Thermistor or Temperature Sensor Fault | View Details |
| E06 |
Dryer does not heat properly, E06 appears intermittently during cycle
|
Moisture Sensor Circuit Fault | View Details |
| E07 |
Dryer drum does not turn, motor hums or stops, E07 displayed
|
Drive Motor or Motor Circuit Fault | View Details |
| E08 |
Dryer overheats or shuts down with E08, exterior of cabinet feels very hot
|
Overtemperature / High Limit Thermostat Trip | View Details |
| E09 |
Dryer will not heat, E09 displayed on gas models
|
Gas Ignition or Gas Valve Fault | View Details |
| E10 |
Dryer will not heat, E10 displayed on electric models.
|
Electric Heater Circuit Fault | View Details |
| E11 |
Dryer stops mid-cycle and displays E11; it will restart but stops again.
|
Motor Overload or Overcurrent Fault | View Details |
| E12 |
Dryer display shows E12; controls are unresponsive or erratic.
|
Main Control Board Failure | View Details |
| E13 |
Dryer beeps and shows E13; the drum light may stay on, and the unit will not start.
|
Door Lock / Door Sensing Error | View Details |
| E14 |
Dryer displays E14 and will not start or stops quickly, often after a power outage.
|
Line Voltage or Power Supply Error | View Details |
| E15 |
Dryer shows E15; drum light and display may flicker, and the unit may shut off unexpectedly.
|
Internal Low Voltage / Control Power Supply Error | View Details |
| E16 |
Dryer displays E16; sensor dry cycles end too quickly or run too long.
|
Humidity / Sensor Dry Calibration Error | View Details |
| E17 |
Dryer displays E17; the drum light works, but the Start button does nothing.
|
Start Button / User Interface Key Failure | View Details |
| E18 |
Dryer displays E18; the drum turns but there is no heat, often after long vent runs.
|
Exhaust Temperature Too Low / Vent Sensor Error | View Details |
| E19 |
Dryer displays E19; the cycle will not start or stops immediately after starting.
|
Drum Motor Tachometer / Speed Sensor Error | View Details |
| E20 |
Dryer displays E20, interior light may stay on, door status is incorrect.
|
Door Open Detection Error | View Details |
| – |
Dryer control panel buttons are unresponsive or respond intermittently.
|
User Interface or Touchpad Failure | View Details |
| – |
Dryer door is hard to open or close, with a scraping noise at the front.
|
Misaligned Door or Worn Front Drum Glide | View Details |
| – |
Dryer door pops open during the cycle, stopping the dryer.
|
Door Latch or Hinge Misalignment | View Details |
| – |
Dryer drum does not turn but motor can be heard running; a burning smell may be present.
|
Broken or Slipped Drive Belt | View Details |
| – |
Dryer drum light does not work, but the dryer otherwise operates normally.
|
Drum Light Circuit Failure | View Details |
| – |
Dryer interior light stays on even when the door is closed.
|
Door Switch Stuck or Misadjusted | View Details |
| – |
Dryer leaves black or brown marks on clothing.
|
Drum Seal or Felt Wear Causing Fabric Pinching | View Details |
| – |
Dryer makes loud rumbling or thumping noises during operation.
|
Worn Drum Support Rollers or Drum Glides | View Details |
| – |
Dryer powers on but will not start when Start is pressed; a click may be heard.
|
Start Circuit or Door Interlock Issue | View Details |
| – |
Dryer produces a burning smell during operation, but clothes are not scorched.
|
Lint or Debris Contacting Heater or Exhaust | View Details |
| – |
Dryer runs but clothes remain damp at the end of an automatic (sensor) cycle; timed dry works normally.
|
Moisture Sensor Not Detecting Properly | View Details |
| – |
Dryer runs but does not heat (electric Monogram dryer, no error code displayed).
|
Heating Element or Thermal Cutoff Failure | View Details |
| – |
Dryer runs continuously and does not shut off at the end of the cycle unless manually stopped.
|
Timer or Control Board Stuck On | View Details |
| – |
Dryer shuts off after a few minutes and will restart after cooling down.
|
Overheating Motor or Thermal Protection Trip | View Details |
| – |
Dryer squeals or squeaks loudly, especially at start-up.
|
Worn Idler Pulley or Drum Bearings | View Details |
| – |
Dryer stops with clothes very hot and wrinkled; the cycle seems too hot.
|
Temperature Regulation Problem | View Details |
| – |
Dryer takes too long to dry clothes, multiple cycles needed, drum feels warm but exhaust airflow is weak.
|
Restricted Exhaust Venting | View Details |
| – |
Dryer vibrates excessively or moves across the floor during operation.
|
Cabinet Vibration / Leveling Issue | View Details |
| – |
Dryer will not start at all; no lights or display, outlet has power.
|
No Power to Control / Blown Thermal Fuse | View Details |
| – |
Gas Monogram dryer runs but does not heat, no error code, igniter may glow briefly or not at all.
|
Gas Burner Ignition Failure | View Details |
| – |
The dryer emits a musty or moldy odor on startup or during drying.
|
Odor from Lint, Residue, or Environmental Contaminants | View Details |
No matching codes found
Advertisements